MTNTK BELT GUARD REPAIR CLIP 10037

The current trend in mountain machines has been to make them smaller and more compact thus limiting the amount of area that can be used for vent surfaces. Deep snow and extreme conditions also put enormous loads on the motor which helps raise the under hood temps shortening belt life and reduces performance. The Blow Hole helps remove that heat via a high output fan

• Active venting system expels hot air even at low ground speeds or when snow is covering vents as opposed to traditional passive venting
• Pulls approximately 140 CFM if air through the hood and clutch area
• Prolongs belt life and helps keep clutches cooler
• Heavy duty welded aluminum design is rugged yet lightweight
• Air is removed from the clutch housing and fan installation does not inhibit or otherwise interfere with belt changes
• Radiated hear from engine is absorbed by the cool incoming air instead of air intake/box thus keeping intake air temps down
• Gives engine a crisper and more consistent feel and makes more power when subjected to heavy powder and hillclimbing
• Belt dust and other fine debris is essentially vacuumed out of under hood area helping to keep clutches and engine compartment cleaner
• Also makes an excellent goggle defogger
• Factory connectors allows true plug and play install and allows for quick disconnect for troubleshooting and working on snowmobile
• Mounting location is clutch side knee panel